Arduino Powered Remote Controlled Flight

Here is a small project i have done after A/Ls free time, a fully home made remote controlled flight using Styrofoam. Both flight and remote controller was powered by arduino nano, and two nRF24L01+ transceiver modules which manufactures specifies that it could obtain 1km range. Two 3 cell LiPo (Lithium Polymer) batteries were used as power resources. 1000kv brushless motor with 30A esc were used to generate trust for the flight and two micro servos for main wing elevators.

For arduino codes visit below link;

GitHub (https://github.com/chandima-b-samarasinghe/arduino-remote-controlled-flight)

 

IMG_20151026_202958
Remote Controller ; arduino nano powered with nrf24L01+ transceiver
IMG_20150717_162707
Flight Design #can’t remember 🙂
IMG_20150717_162734
You can get a rough idea about flight size, since the tile size is 1ft x 1ft
IMG_20151026_202007
Some other flight designs
IMG_20150620_221051
Another angle 🙂

GitHub (https://github.com/chandima-b-samarasinghe/arduino-remote-controlled-flight)

Leave a Reply

Your email address will not be published. Required fields are marked *